24
ORANGE (+) accessory output
Connect this wire to the accessory wire in the vehicle which powers the climate control system.
PINK (+) ignition output
Connect this wire to the ignition wire in the vehicle.
PINK/WHITE (+) second ignition/accessory output
Connect this wire to the second ignition/accessory wire in the vehicle. (See selectable menu feature 2-9.)
NNOOTTEE::
For vehicles that do not have a second ignition/accessory wire, this connection is not required.
RED/WHITE (+) 12V input
If additional current capacity is needed cut this wire, add a fuse adequate for the circuit to be sup-
plied, and connect to an additional 12V source.
4-pin satellite harness wire connection guide
BLUE (-) status output
For use when immobilizer bypass is required.
ORANGE (-) 200mA 2nd accessory output
To drive relay for 2nd or 3rd accessory.
VIOLET (-) 200mA starter output
To drive relay for 2nd starter.
PINK (-) 200mA 3rd ignition output
To drive relay for 2nd or 3rd ignition.
remote start secondary harness (H3) wire
connection guide
H3/1 BLUE/WHITE (-) status output
This wire supplies a 200mA output as soon as the module begins the remote start process. The H3/1
BLUE/WHITE wire can also be used to activate the defogger trigger (latched/pulsed) 10-seconds
after the remote start engages. (See the Feature Descriptions section in this guide for details about
programming this output.)
To Next Page
Loading...
