2 – 8
(1) MODEL NAME & READY OK
These characters are displayed when the machine runs in the normal
condition. In case that an abnormal condition occurs while running, the
trouble message appears immediately. When the trouble message is shown
on the screen, immediately stop operating and solve the problem, and then
run equipment again.
(2) ERROR DISPLAY?
This mode indicates the trouble message of the machine. In case that a
trouble occurs while equipment is running, No.1 mode displayes only one
message, the highest trouble message. According to the working conditions,
however the trouble may happen compositely from several parts, so that this
mode displays upto 10 messages at maximum. Therefore, in case a trouble
occurs in No. 1, be sure to check if additional trouble message exists in
this mode before troubleshooting.
(3) DISTANCE DISPLAY?
This mode indicates the travel distance of the machine. The travel distance
consists of two distances; the total travel distance up to now from the
machine starting and the temporal travel distance upto now from the operator
setting. The mode switch usage is as follows; Press “ENTER” in (DISTANCE
DISPLAY?) mode to move into the lower level mode. Each time the mode
switch is pressed again, the mode shifts in the order of (TOTAL DISTANCE
DISPLAY?: total travel distance), (TEMP DISTANCE DISPLAY?: temporal
travel distance), (TEMP DISTANCE RESET?: temporal travel distance
initialization), and ( EXIT[ENTER]: move to the higher level mode). If you
want to check the total travel distance, press “ENTER” in the mode, and the
total travel distance will be displayed on LCD screen. The temporal travel
distance checking is available in the same manner with the total travel
distance checking. TEMP DISTANCE RESET? (Temporal travel distance
initialization) increases the temporal travel distance up to now starting from
“0km”. This mode is helpful for operator to check daily or weekly traveling
distance of the machine.
13. DRIVING AND OPERATING
To Next Page
Loading...
