Clear-Com Communication Systems
ICS-102/62 Intercom Panel Instruction Manual
1-5
automatically removed. To answer the call, push the Answer Back
selector. The red LED will turn off and the green LED will turn on,
indicating an active talk path to the caller. The talk path is active for as
long as the selector is held.
Note: The Answer Back selector cannot be latched; it is a
momentary-only function.
Calls from panels or interfaces assigned to panel selectors will only be
indicated by their associated LEDs.
ANSWER-BACK LABEL SELECTION
If another call comes in while using the answer-back selector:
• The user will hear the caller’s voice.
• The label will be placed in the answer-back stack.
To answer the next caller:
1. Push up on the Answer Back selector to remove the current caller’s
label.
2. Press down on the Answer Back selector to talk to the next caller.
REMOVING LABELS FROM THE ANSWER-BACK
STACK
Any label will be automatically removed from the stack if it is not
answered within a certain time interval, which is set by the
answer-back auto-clear time in the configuration program.
To manually remove the current caller’s label from the answer-back
stack, push up on the Answer Back selector.
FUNCTION SELECTORS
Two dual-function toggle switches allow you to choose among the
following four functions:
• Panel Mic
• Speaker On
• Mic On
• Listen Level
PANEL MIC SELECTOR
This selector selects the panel or headset microphone. If a headset is
plugged in, the panel will automatically switch to headset microphone
operation. If the headset is unplugged, the panel will automatically
switch back to panel microphone operation. The LED will be on when
the panel microphone is active.