Clear-Com ICS-102 - Coax Digital; Matrix Panel Miscellaneous Connector Wiring

Clear-Com Communication Systems
ICS-102/62 Intercom Panel Instruction Manual
2-4
Figure 2-2: Matrix Frame to Digital Panel Wiring Using RJ-45
Coax Digital
Coax digital wiring requires double-shielded 24 AWG conductor CAT-6
Enhanced STP cable connected to a 75-ohm (RG59) braid- shielded
coax cable with a BNC-16 adaptor.
Pair 1 transmits and receives multiplexed digital and analog between
the matrix port and the panel.
Note: Ensure that the Select switch on the panel’s rear panel is in
the correct position for the intended use.
Figure 2-3: Matrix Frame to Digital Panel Wiring Using BNC-16 and
Coax
MATRIX PANEL MISCELLANEOUS CONNECTOR
WIRING
Most local devices connect with the panel via the Miscellaneous
connector.
Pair 1
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Matrix Frame End
ATT-T568B (Modular Jumpers Wired One to One)
Panel E
nd
No Connection (NC)
No Connection (NC)
No Connection (NC)
M
ultiplexed Data/Audio
M
ultiplexed Data/Audio
No Connection (NC)
No Connection (NC)
No Connection (NC)
Pair 1
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
Matrix Frame End
Panel End
No Connection (NC)
No Connection (NC)
No Connection (NC)
M
ultiplexed Data/Audio
M
ultiplexed Data/Audio
No Connection (NC)
No Connection (NC)
No Connection (NC)
BNC-16