Clear-Com Communication Systems
ICS-102/62 Intercom Panel Instruction Manual
1-9
associated with the active two-way radio talk selectors operate
normally regardless of the PTT status. This input only controls
latched talks.
Programmable Relay
Each Eclipse system panel includes a relay controlled by the system
program and independent of the local panel function. This relay can be
assigned to any label(s) in the system, which will activate whenever a
talk or listen is set to that label(s). If activating the relay is the only
action desired, assign the relay to a “control” label. See the Eclipse
Configuration System Manual for more details.
The relay can activate an external device, such as an applause light in
a studio, a cue light, or a security door lock. Any programmable relay in
the system can be activated from any panel in the system, including a
direct-inward-access caller.
Mute Relay
The mute relay is activated whenever any talk selector is activated at
the panel. The mute relay is commonly wired such that whenever it is
activated, the volume of the monitor speaker in that room is decreased
(muted).
OPT-100 AUXILIARY AUDIO OPTION
The OPT-100 Auxiliary Audio option provides the following features:
• Hot Mic output
• SA audio and relay outputs
• Auxiliary audio line level output.
Hot Mic Output
The Hot Mic output is a balanced, line-level, transformer-isolated feed
of the signal from the currently selected microphone (panel or
headset). The Hot Mic output is active regardless of whether the panel
has talk paths set and regardless of the front-panel’s control settings.
Studio/Stage Announce Audio and Relay Outputs
The SA output is a balanced, line-level, transformer-isolated feed with
the same signal sent to the Hot Mic output, except it is only active
when the SA button on the panel’s front panel is pressed or when
activated by Logic Input #1 or #2, which is configured for the Studio
Announce Function.
To Next Page
Loading...
Need help?
General
