EasyManuals Logo

Clear-Com ICS-102 User Manual

Clear-Com ICS-102
81 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
Clear-Com Communication Systems
ICS-102/62 Intercom Panel Instruction Manual
2-1
INSTALLATION
INTRODUCTION
This chapter describes the installation of the ICS-102/ICS-102T and
ICS-62/62T intercom panels, including:
• Panel placement
• Wiring
• Mains AC power
• Adjustments
• Configuration
• Accessory panels
MOUNTING PANELS
Locate all intercom panels at comfortable heights for operation and
leave at least 2 inches (51 mm) of clearance behind the rear of the
panel’s chassis to allow for cable connectors.
Accessory panels, that are intended to expand or enhance panel
operation, are usually mounted next to or near the panel with which
they are associated. Leave at least 2 inches (51 mm) of clearance
behind the rear of the panel to allow for cable connectors.
Accessory panels can be located as far as 25 ft. (7.6 m) away from the
panel. A 6-ft. (1.8 m) cable is supplied to connect them.
WIRING
This section provides detailed wiring diagrams for all panels’ wiring
systems.
Eclipse uses either a twisted, 4-pair transmission, a single-pair twisted,
or a coax scheme between the panel and the frame using the industry
standard RJ-45 connector. Refer to Installing an Eclipse Matrix
System: An Overview for RJ-45 connector installation and use, and the
type of cable needed for connection between panels and frames.
Most panels have a DB-15M and an RJ-45 connector to connect them
to the frame. Panels with only a DB-15M connector include a kit
containing one DB-15F/RJ-45 adapter. The adapter allows the use of
RJ-45 connectors on both ends of the connection between the frame
and the panel.
2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Clear-Com ICS-102 and is the answer not in the manual?

Clear-Com ICS-102 Specifications

General IconGeneral
BrandClear-Com
ModelICS-102
CategoryIntercom System
LanguageEnglish

Related product manuals