What to do if my Cleco Tools Power Tool output signal is not linear?
If the output signal of your Cleco Tools Power Tool is not linear, it may be because the measuring hub was over-stretched. In this case, send the transducer to DGD for repair or recalibration.
How to fix a Cleco Tools BTSE DGD-IS that does not turn on?
If your Cleco Tools Power Tool DGD-IS does not turn on, there are several potential causes: * The motor might be defective: Replace the DGD-IS. * The gearing might be defective: Replace the DGD-IS. * The tightening module TSE/TUSE might be defective: Replace the DGD-IS. * The cable might be defective: Replace the cable.
General| Brand | Cleco Tools |
|---|---|
| Model | BTSE series |
| Category | Power Tool |
| Language | English |
To Next Page