Cleco Tools BTSE series - Ambient Conditions; EMC (Electromagnetic Compatibility)

77b_Sicherheit_bedingt-en.fm, 06.09.2011 P2077SB/EN 2011-09 9
Safety
1
• Secure the DGD-IS to an electroconductive mounting plate.
• Only cable types approved by DGD may be used.
• Only accessory parts approved by DGD may be used.
• Unauthorized alterations, repairs and modifications are prohibited for reasons of safety and product
liability.
• Only operate the tightening system indoors.
1.6 Ambient conditions
Do not operate the fastening system in an explosive atmosphere.
1.7 EMC (Electromagnetic compatibility)
• The tool complies with the following applicable EMC standards:
- DIN EN 61 000-3-2
- DIN EN 61 000-3-3
- DIN EN 61 000-6-2
- DIN EN 61 000-6-4
• The filters required to fulfill the EMC standards are integrated in the system components.
• Shielded cables offer protection against irradiating and radiating interference.
• All cable shields are connected to the shield terminals on the nutsetter control unit and the plug casing
on the DGD-IS.
NOTE
➔ Always remove the complete DGD-IS from a unit.
➔ A repair is only permitted by DGD authorized personnel. If repair is required, send the complete
DGD-IS to Sales & Service Center (see backside).
➔ Do not open the transducer, offset attachment or angle head attachment as this will void the
warranty. A repair is only permitted by DGD authorized personnel. If repair is required, send the
complete component to Sales & Service Center.
➔ Do not open the TSE/TUSE or CPS3 as this will void the warranty.
This does not include the service panel. A repair is only permitted by DGD authorized personnel. If
repair is required, send the complete component to Sales & Service Center.
➔ Read the following documents when replacing the DGD-IS
• This System Handbook (see 16 Maintenance / Service, page 77)
• Service Manual DGD-IS
• Assembly instructions DGD-IS
• Spare part sheets
System components Ambient temperature Relative humidity Working height
DGD-IS
32 to 113 °F
(0 to 45 °C)
0 to 90 %
no condensation
up to 3000 m above
sea level
mPro400GC-M
PDB-CPS…
CP3-…-JH
TSE/TUSE
Motor
CPS3 32 to 158 °F
(0 to 70 °C)