Cleco Tools BTSE series - Default Chapter; Table of Contents

P2077SB-EN_2011-09_m-Pro-400S-DGD-IS_BTSEIVZ.fm, 06.09.2011 P2077SB/EN 2011-09 3
Contents
1 Safety 7
1.1 Warnings and notes ....................................................................... 7
1.2 Basic requirements for safe working practices ..................................... 7
1.3 Operator training................................................................................... 8
1.4 Personal protective equipment ............................................................. 8
1.5 Designated use..................................................................................... 8
1.6 Ambient conditions ............................................................................... 9
1.7 EMC (Electromagnetic compatibility).................................................... 9
1.8 Noise................................................................................................... 10
2 Transport / Storage 10
3 System description 11
3.1 Components ....................................................................................... 11
4 First Operation 13
5 DGD intelligent spindles 15
5.1 General technical data........................................................................ 15
5.2 Catalogue data ................................................................................... 16
5.3 Component overview.......................................................................... 20
6 Tightening module TSE/TUSE 23
6.1 Description.......................................................................................... 24
6.2 General technical data........................................................................ 24
6.3 "Ready" LED....................................................................................... 25
6.4 Service panel...................................................................................... 25
6.5 Internal assemblies............................................................................. 27
7 Attachment 29
7.1 Centric Attachment ............................................................................. 29
7.2 Offset attachment ............................................................................... 29
7.3 Angle head attachment....................................................................... 30
7.4 Spring collet – Optional....................................................................... 31
8 Transducer 33
8.1 Electrical Data..................................................................................... 34
8.2 Pin configuration of transducer........................................................... 34