12 P2552HW | 2021-04 Apex Tool Group
1
EN
5 Pin Assignment
This chapter describes the Cleco Production Tools specific
connectors. Standard plugs are not considered. All connec-
tions are short-circuit proof.
X5 – Serial port for additional devices
• All outputs provide RS232 conforming signals.
• The inputs allow voltages in the range from -15 V to
+15 V.
- Voltages < 0.8 V correspond to a zero.
- Voltages > 2.4 V are interpreted as a one.
- Open inputs are preset to zero using a pulldown
resistor.
• The power supply pins are connected directly to the
main board power supply
.
X7 – Anybus Compact Com
X21 – TSnet System Bus Out
Interface port for TSnet cable.
X22 – TSnet System Bus In
X23 – Supply
X24 – Tool Connector Digital
for 30/50/70/BD Series
Note
Do not connect or disconnect any device
during operation. Doing so may result in a
system reset.
Pin RS232-1 9 Pin D-Sub Male
with Screw Lock
1 –
2 RxD
3 TxD
4 –
5 GND
6 –
7 RTS
8 CTS
9 –
Module Order no.
PROFINET M40 RJ45 544357PT
PROFIBUS M40 M12 962291PT
PROFIBUS M40 DB9 962292PT
DeviceNet M40 962293PT
PROFINET M40 M12 962294PT
Ethernet/IP M40 RJ45 2 port 962297PT
Modbus/TCP M40 RJ45 2 port 962299PT
Note
Do not combine Anybus Compact Com M40
modules with Anybus CC M30 modules.
Pin Signal 8 Pin M12 Socket
Circular Connector X-Coded
1 Tx +
2 Tx -
3 Rx +
4 RX -
5 0 VDC
6 0 VDC
7 +24 VDC
8 +24 VDC
Pin Signal 8 Pin M12 Male
Circular Connector X-Coded
1 Tx +
2 Tx -
3 Rx +
4 RX -
5 0 VDC
6 0 VDC
7 +24 VDC
8 +24 VDC
Description IEC Conncetor
C14
Connector with Fuse Holder
2-Pin, 5 × 20 mm,
16 A Slow-Blow
Fuse, Schurter type 0034.3129,
5 × 20 mm, 16 AT, 250 VAC,
Interrupting Current, 100 A
Note
Use plug locking mechanism.
See Quick Installation Guide.
Pin Signal M23 Circular Connector
1-3 Power
4 PE
(functional
ground)
5 Tool bus
54
3
2
1
8
7
6
45
6
7
8
1
2
3
1
2
3
4
5
To Next Page
Loading...
