67
Step 1
Prepare car seat for Forward-Facing
Installation:
• If Rear-Facing Base or Anti-Rebound Bar is
attached, remove it now, see “Installing/
Removing Rear-Facing Base” on page 82,
and “Installing/Removing Anti-Rebound
Bar” on page 85.
Step 2
Select a Forward-Facing vehicle seating
location which has a vehicle belt which
can be used with this seat and a top tether
anchor point.
Step 3
If the vehicle seat back is adjustable, make
sure the seat back is locked in a more upright
position. Refer to vehicle owner’s manual for
recommended seat back angle. DO NOT
install or use this car seat while the vehicle
seat back is excessively reclined, as shown in
Figure 95.
Figure 95
To Next Page
Loading...
