82
Installing/Removing
Rear-Facing Base
TO INSTALL REAR-FACING BASE
Step 1
Place the car seat on a clean, stable surface
with the inside of the seat facing down.
Step 2
Line the Rear-Facing Base Retention Hooks
up with the openings in the bottom of the
car seat, as shown in Figure 127. Insert the
Rear-Facing Base Retention Hooks into the
openings and slide the base down until you
hear the Rear-Facing Base Release Lever
“click” to lock the base on as shown in
Figure 128.
Step 3
Pull up on Rear-Facing Base to check that it is
locked in place.
Figure 127
Figure 128
Operations and Adjustments
To Next Page
Loading...
