56
Step 7
Check both LATCH Connector Lock Indicators on the
side of the LATCH Connectors to make sure they have
changed from solid red (unlocked) to solid green
(locked) as shown in Figure 44.
Pull forward on the Base to make sure it is securely
attached to the vehicle’s LATCH lower anchors on both
sides. If not, go back to Step 5.
NOTE: If LATCH Connectors fail to connect to the
vehicle’s LATCH lower anchors, you can still use the
Base by installing with a vehicle belt. See “Installing
Car Seat Base with Vehicle Belt” on page 64 of this
manual.
Figure 44
To Next Page
Loading...
