Clemco BNP Series User Manual (English)

Questions and Answers:

W
William MilesSep 6, 2025
What to do if my Clemco BNP Industrial Equipment has poor cleaning rate?
- C
  Cathy HansonSep 6, 2025
  If your Clemco Industrial Equipment has a poor cleaning rate, start by checking if there's enough blast media in the circuit and refill if necessary. Ensure the media metering valve is correctly adjusted. Check the air supply for reduced air pressure, inspecting the moisture separator, pressure regulator, and nozzle. A blocked blast hose, gun, or nozzle can also cause this; try pushing the nozzle against an elastic object while stepping on the foot pedal, or disassemble and clean the hose or gun. Also, a worn nozzle can reduce cleaning rate, so replace if needed. Finally, moist blast media can cause issues; remove the moist media and address the source of moisture.
A
angelagarciaSep 7, 2025
Why Clemco BNP Industrial Equipment has abnormally high media consumption?
- G
  George BrownSep 8, 2025
  Abnormally high media consumption in Clemco Industrial Equipment can be caused by a cyclone door that is open or leaky, requiring a gasket replacement. It may also be due to using media that is too fine or lightweight; in this case, install and adjust a supplementary Vortex cylinder.
M
michaelharperSep 9, 2025
What to do if no air and media comes out of Clemco BNP nozzle?
- S
  Samuel HollowaySep 9, 2025
  If no air and media are coming out of the nozzle of your Clemco Industrial Equipment, make sure the door interlocks are actuated. If a foot pedal was newly installed, ensure the pneumatic hoses are connected properly. A polluted or blocked moisture separator can also cause this issue, so cleanse it. Finally, check the control lines for leaks, which may require a second person to assist.
M
Michael JacksonSep 12, 2025
How to fix static shocks from Clemco BNP Industrial Equipment?
- D
  Dylan HuynhSep 12, 2025
  To address static shocks from your Clemco Industrial Equipment, improve the grounding of the cabinet. In exceptional cases, use a supplementary ground wire between the blast gun and the cabinet wall.
T
taylorjessicaSep 12, 2025
What to do if air only (no media) comes out the nozzle of Clemco Industrial Equipment?
- P
  Philip PetersonSep 12, 2025
  If only air (no media) is coming out of the nozzle of your Clemco Industrial Equipment, first check if there is blast media in the blast circuit and refill if necessary. Another possible cause is moist media. If the media is moist, remove it and eliminate the source of humidity in the air supply.
C
charles95Sep 14, 2025
What to do if dust comes out of the blower of Clemco BNP Industrial Equipment?
- A
  Alexander MedinaSep 14, 2025
  If dust is coming out of the blower of your Clemco Industrial Equipment, the dust filter gasket may be defective and needs replacement. Alternatively, the cartridge itself may be defective and require replacement.

Clemco BNP Series Specifications

General

Model	BNP Series
Type	Pneumatic Blast Nozzle
Capacity	Varies by model
Air Consumption	Varies by model
Material	Tungsten Carbide, Boron Carbide, or Ceramic
Bore Size	Varies by model