BIOS Utilities
Advanced Menu 5 - 9
5
Bluetooth Power Setting (Advanced Menu > Advanced Chipset Control)
You can adjust the Bluetooth module power setting to your preference. The default
setting (Disabled) will see the Bluetooth module powered off when the system is
started up or restarted. Enabling the power setting will have the module retain the
last power status (on or off) before any restart or shut down.
Intel(R) Rapid Start Technology (Advanced Menu)
Enable/disable Intel(R) Rapid Start Technology from this menu. The rapid start
hibernation mode can resume power within 5 to 6 seconds and can remember your
computer's state with zero power.
SATA Mode (Advanced Menu)
You can configure SATA (Serial ATA) control to operate in IDE (native/compati-
ble), AHCI (Advanced Host Controller Interface) or RAID (Redundant Array of In-
dependent disks) modes from this menu. The SATA Mode should be set BEFORE
installing an operating system, and after you have backed up all necessary files and
data (see sidebar). See “Setting Up SATA RAID or AHCI Mode” on page 7 - 2 for
details. Make sure you install the Intel Rapid Storage Technology application if
you have set the SATA Mode to RAID or AHCI “IRST Driver Installation” on
page 7 - 9.
SATA Mode
Selection
If you have installed the
Windows 7 operating
system with either IDE,
AHCI or RAID mode en-
abled, DO NOT disable
the set mode (if you wish
to disable the set mode
you will need to reinstall
the Windows 7 OS).
To Next Page
Loading...
Need help?
General
