Clevo P150e

Troubleshooting
8 - 22 Installing Windows 7 (pre Service Pack 1) for RAID Systems with Advanced Format
8
4. Press a key at system startup to begin installing Windows from your Microsoft Windows 7 disc (make sure
the DVD device is set at the top of the Boot Sequence in the BIOS - see “Boot Option Priorities (Boot
Menu)” on page 5 - 14).
5. Click Install Now.
6. Make sure your USB Flash drive, external USB hard disk or external USB floppy disk drive and floppy diskette
is attached to one of the USB ports on the computer.
7. Click “I accept the license terms” tickbox and click Next.
8. Click Custom (advanced).
9. Click to select Load Driver when the “Where do you want to install Windows?” screen appears.
10. Click Browse and browse to the location you copied the files to on your USB Flash drive, external USB hard
disk or external USB floppy disk drive and floppy diskette (X: denotes your USB Flash drive, external USB hard
disk or external USB floppy disk drive):
• Windows 7 32bit - X:\f6flpy-x86\iaStor.inf
• Windows 7 64bit - X:\f6flpy-x64\iaStor.inf
11. Click Next (or format the drive to your preferences).
12. Follow the on-screen instructions to install the Windows 7 operating system.
13. Install the Windows drivers from the Device Drivers & Utilities + User’s Manual disc as per Table 4 - 1, on
page 4 - 3 (make sure you install the Intel Rapid Storage Technology driver - see “IRST Driver Installation” on
page 7 - 9).