CMC S23 - Page 91

MAN.241 Rev.5 ENG - Use and maintenance manual S23 page 90 of 127
Check that there is no
trace of clashes on
the equipment.
It is
strictly forbidden
to use the MEWP.
Contact the Ser-
vice.
C.M.C.
8.2 Weekly maintenance (or
every 40 hours)
Operations
If negative
result:
by
Check the absence of
splits, cracks, rust
on the MEWP counter
frame (use torches or
lamps to inspect the
internal part under the
frame).
It is
strictly forbid-
den to use
the MEWP.
Contact the
Service.
C.M.C.
Check the cleanli-
ness of the endo-
thermic engine and
auxiliary motor* air
filters.
Replace-
ment.
USER/
C.M.C.
Check the cleanli-
ness of the hydraulic
filters.
Replace-
ment.
USER/
C.M.C.
8.3 Monthly maintenance (or
every 120 hours)
Operations
by
Greasing of pins and movable
parts.
USER /
CMC
Washing of the equipment.
USER /
CMC
Check the tightening of the bolts of
the bearing, the geared power and
the frame.
USER /
CMC
As regards greasing of pins and movable parts, rota-
tion group (bearing) greasing is particularly im-
portant. For this component follow the indications be-
low:
1. turn on MEWP’s engine;
2. lift the pantograph (Picture 88);
3. rotate the turret of 90° counterclockwise
(Picture 88);
4. turn off MEWP’s engine;