CNCroom MB3 - Page 59

Figure 48, Configure menu and step sequence ..................................................................................... 36
Figure 49, Entry to ESS and Keyboard configuration ............................................................................. 36
Figure 50, ESS IP address and buffer size .............................................................................................. 37
Figure 51, Motor command mode ........................................................................................................ 38
Figure 52, Spindle Setup ........................................................................................................................ 38
Figure 53, Pins Config and Alias Names ................................................................................................. 39
Figure 54, Pins Config and Alias Names (continue 1) ............................................................................ 39
Figure 55, Pin Alias Names (continue 2) ................................................................................................ 40
Figure 56, Input Signals Mapping .......................................................................................................... 40
Figure 57, Input Signals Mapping (continue 1) ...................................................................................... 41
Figure 58, Output Signals Mapping ....................................................................................................... 41
Figure 59, Output Signals Mapping (continue 1) ................................................................................... 42
Figure 60, Output Signals Mapping (continue 2) ................................................................................... 42
Figure 61, Homing, depends on the user’s choice ................................................................................ 43
Figure 62, Backlash, all default value .................................................................................................... 43
Figure 63, Mach4 General Configuration .............................................................................................. 44
Figure 64, Mach4 Plugins enabled ......................................................................................................... 44
Figure 65, Mach4 Motors profiles ......................................................................................................... 45
Figure 66, Mach4 Axis Mapping ............................................................................................................ 45
Figure 67, Mach4 Homing and Soft Limits............................................................................................. 46
Figure 68, Mach4 Input Signals ............................................................................................................. 46
Figure 69, Mach4 Input Signals (continue 1) ......................................................................................... 47
Figure 70, Mach4 Input Signals (continue 2) ......................................................................................... 47
Figure 71, Mach4 Output Signals .......................................................................................................... 48
Figure 72, Mach4 Output Signals (continue 1) ...................................................................................... 48
www.CNCRoom.com Page 59