Need help?Do you have a question about the CNCroom MB3 and is the answer not in the manual?
General| Axis | 3 |
|---|---|
| Connectivity | USB |
| Interface | USB |
| Power Supply | 24V DC |
| Storage Temperature | -20°C to 70°C |
| Humidity | 10% to 90% non-condensing |
Important safety warnings and handling instructions for the MB3 board.
Steps and guidance for establishing PC communication with the ESS.
Details on the power requirements and connections for the MB3 board.
Instructions for connecting motor drives to the MB3 for axis control.
Describes NPN/PNP and Sink/Source input configurations.
Guides on connecting switches using internal and external power.
Instructions for connecting industrial sensors to the MB3.
How to connect MPG/Encoder devices to the MB3.
Details on MB3's transistor sink outputs.
Information on the MB3's built-in relays and their uses.
Explanation of the charge pump signal and its interlock function.
Complete procedure for calibrating the analog output.
Explanation of how to use solder bridges for board modifications.
To Next Page