Appendix B: Command reference
98-143082-D SMS remote commands 106
SMS reject responses
name>
NA
CLR
User name associated with APN.
Placeholder when no APN user name is specified. Note that any previously
entered user name is maintained.
User name is not used.
a. Position SMS response is only for future use, and should be set to NA
Parameter Values Meaning
Parameter Values Meaning
<wakeup> 0
1
NA
Set to NA. This parameter must be present, but is ignored
because the
EXPLORER 510 does not support wake up functions.
<wanmode> 0
1
2
3
4
Cellular modem if available at power-up
User selection
BGAN only
Cellular modem only
Not valid for EXPLORER 510
<wdog_enable> 0
1
NA
Disabled.
Enabled.
Placeholder when no value is specified. The existing setting applies. Used if
you want to change one of the other parameters without changing the
enabled/disabled setting.
<wdog_op> 1
2
Get watchdog configuration.
Set watchdog parameters.
Reject Response SMS Possible Cause
ACT/DEACT PARM PROBLEM The <IP addr> provided for an ACTIVATE or
DEACTIVATE command is incorrect (for
ACTIVATE, it must be in same subnet as the
EXPLORER 510 IP and not be the
EXPLORER 510 IP; for DEACTIVATE, it must
exist as a local or global IP address in the
existing PDP table).
ATCO ERROR Unable to send AT command to ATC handler.
COMMAND NOT SUPPORTED Attempt to use an SMS command not
supported by the EXPLORER 510.
ERROR: TERMINAL BUSY An ACTIVATE or DEACTIVATE command is
in progress.
To Next Page
Loading...
