Chapter 4: Configuration
98-143082-D Terminal settings 57
To enable or disable Network Service Device (NSD)
If you have an Inmarsat GX system together with your EXPLORER 510 and you want to use the
EXPLORER 510 as backup when the GX service is not available, you can acquire a Network
Service Device from Inmarsat. The NSD will use a PPPoE connection to allow your system to
use the BGAN service when your system is out of GX spot beam coverage. To enable NSD, do
as follows:
1. In the Terminal settings page, locate the NSD section.
2. Select Enable if you want to use an NSD with your EXPLORER 510.
For information on PPPoE, see To change the APN for PPPoE on page 63.
To enable or disable the pointing sound
The EXPLORER 510 can make a sound to guide you through the pointing procedure (default
enabled). To enable or disable the pointing sound, do as follows:
1. In the Terminal settings page, locate the Audio indication section.
2. Select Audio assisted pointing if you want to use a pointing sound to assist your
pointing process.
3. At Audio assisted pointing volume (0 - 100) type the volume level you want for the
pointing sound.
4. Click Save.
To select the type of navigation system (GNSS)
To select which navigation system to use with your EXPLORER 510, do as follows:
1. In the Terminal settings page, locate the GNSS section (Global Navigation Satellite
System).
2. Select GPS, GLONASS, GPS and GLONASS or BeiDou-1.
3. Click Save.
To select the language
The default language of the web interface is English. You can change the language to French,
German, Russian, Spanish, Chinese or Japanese.
To change the language, do as follows:
1. In the Terminal settings page, locate the Language section.
2. Select a language from the list and click Save.
It may take some minutes for the EXPLORER 510 to change the navigation system.
To Next Page
Loading...
