Chapter 4: Configuration
98-143082-D Advanced settings 70
2. Select Enable watchdog.
3. Select the Watchdog interval.
The interval can be from one hour up to 21 days.
4. Type in the Primary and optionally the Secondary and Tertiary IP address.
This is the IP address(es) of the server(s) to which the terminal will send ping commands.
The terminal will start sending ping commands to the Primary IP address. If there is no
response after 10 attempts, the terminal will send up to 10 ping commands to the
Secondary and then the Tertiary IP address, if available. If no response is received from
any of the IP addresses, the terminal will eventually restart.
5. Enter the APN (and user name and password if required) to use for the data connection.
6. Click Save.
Next run time: This field at the bottom of the page shows what time the Terminal watchdog
will run next (UTC time).
Data limits
You can set a limit for the use of BGAN data services with the EXPLORER 510 system.
If you have entered the BGAN call charges in the menu Call charges, the system
automatically calculates and displays the maximum charges for your BGAN data sessions.
Once the entered limit is reached, the connection is automatically stopped. This is recorded in
the data log. To continue using the data service you must start a new connection by clicking on
the desired connection on the startup page.
To set data limits, do as follows:
1. Under Advanced, select Data limits.
2. Select the type of connection you want to limit.
3. Type in the amount of data or time allowed and select the appropriate units.
4. Select Enable.
5. Click Save to save the settings.
If no IP addresses are entered, pinging is skipped but the other actions still apply.
When the Terminal watchdog is enabled, you must reboot the terminal before
the Watchdog settings are activated.
Thrane & Thrane A/S does not take responsibility for the correctness of the estimated
charges. This calculation is only a rough estimate of the charge, based on the tariff
entered by the user. Also, the airtime provider may have different methods of
calculating the charge.
If you have enabled automatic activation of the Standard data connection and you
set a data limit for the Standard data connection, automatic activation is disabled.
To Next Page
Loading...
