CB-MF-SOP-002
A/1
6
2 Instrument Installation
2.1 Accessories List
Power cord 2pcs
RS232 1pc
USB cable 1pc
1394 wire（1394 special for camera）or network cable（special for webcam） 1pc
VGA cable 1pc
Fuse（T6.3AL250V） 2pcs
Fuse（T3.15AL250V） 3pcs
Liquid waste barrel 1pc
Cleaning fluid barrel 1pc
Feeding disk 1pc
Catheterφ6 1pc
Catheterφ8 2pcs
Rotating disk 1pc
Former rail 1pc
Rear rail 1pc
Feeding module 1pc
Counting chamber bar (contain 50 visible elements counting chamber) 12pcs
Test tube + Test tube cap 100pcs
Test tube rack 10pcs
Product Manual 1pc
Computer host 1pc
2.2 Packaging
Preparations
Caution
⚫ Inspect parts are intact comparing to the accessories list before the instrument installed. If the
package is incomplete or damaged, please contact your distributor immediately, otherwise,
continue to read the following operation.
⚫ Don't place the instrument in direct sunlight, because of the strong sunlight may interfere with
the instrument of optical sensors.
S80 is packed with foam model and wooden case in transportation. Before installation, clean
the table of the instrument to be placed, and need a solid and stable table of 100 x 200 cm that can
support the equipment of 100 kg. Refer to the packing list above for the detailed number of parts
Biohazard risk
This instrument is likely to be infectious and pathogenic during use. Please
discard it as biological waste according to local regulations.
To Next Page
Loading...