4.2.2 Live
Live:
• Camera Name: Label the selected camera (up to 30 characters)
• Colour: Click on ‘Setting’ to adjust Brightness, Hue, Saturation and Contrast settings for each
camera
Main Monitor:
• Display Mode: Select between 1x1 or 2x2 view
NOTE: If 1x1 is used, Start/Stop Scan can be used on
the viewing screen to automatically change between
cameras.
• Interval[S]: Select the interval that Start/Stop
Scan should use
• Previous/Next Group: If 1x1 display mode is used, cameras can be re-ordered for when Start/
Stop Scan is used
Video Blind:
• Mask Area Setting: Mask areas of the camera that you don’t want recorded. Useful for hiding
personal information from recordings. To activate, select ‘Setting’, then use the mouse to draw
a rectangle over the area you want ‘masked’. To remove the masks, select ‘Default’ from the Live
menu.
Default - Reset the displayed settings to factory defaults
Apply - After all changes are made, click the ‘Apply’ button to save
Exit - If you want to cancel after making any changes, click ‘Exit’ to exit the menu without changes
IMPORTANT NOTE: Always click ‘Apply’ after making any changes within the menu system. If you do
not click ‘Apply’, your changes will not be saved
DVR Menu
To Next Page
Loading...
