2110 series Manpack Transceiver compliance
10 Manpack Transceiver 2110 series Getting Started Guide
FCC compliance
FCC Part 90 certification
The 2110 series Manpack Transceiver has been tested and
certified to FCC Part 90 (FCC identifier code DYY2110).
FCC Part 15 compliance
Any modifications made to the 2110 series Manpack
Transceiver, the 3121 AC Battery Charger or 3123 Fast AC
Battery Charger with battery packs that are not approved by
the party responsible for compliance may void your
equipment’s compliance under Part 15 of the FCC rules.
The 2110 series Manpack Transceiver, the 3121 AC Battery
Charger and 3123 Fast AC Battery Charger with battery packs
have been tested and found to comply with the limits for a
Class B device, pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by switching
the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and
receiver
• connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• consult the dealer or an experienced radio/TV technician
for help
To Next Page
Loading...
Need help?
General
