Getting started
46 Manpack Transceiver 2110 series Getting Started Guide
Making a selective call
To make a selective call:
1 Press CALL.
1 Enter the address of the station you want to call, scroll to
the type of call you want to make, then press CALL.
NOTE
The call types available depend upon the
options installed in your transceiver.
Call type Icon Used for...
Channel Test Testing the audible quality of a channel in a
Codan Selcall or Open Selcall network.
Replacing LQA information for an
ALE/CALM network (if you have the MIL-
STD-188-141B ALE option installed,
2110 only).
Emergency Sending an emergency alert tone with a call.
Get Position Requesting the location of a remote transceiver
with a GPS receiver connected and enabled.
Get Status Requesting diagnostic or configuration
information from a remote transceiver.
Message Sending a message to a remote transceiver.
Phone Sending a call to a radio/telephone
interconnect unit, which connects the call to
the public telephone network.
To Next Page
Loading...
Need help?
General
