The front panel
34 Manpack Transceiver 2110 series Getting Started Guide
Hot keys
Hot keys enable you to perform a task quickly. The transceiver
comes with some standard hot keys programmed; the keys are
labelled with the corresponding task performed. You can also
create your own hot keys (see the reference material on the
enclosed CD).
Table 6: Standard hot keys
Hot key Function
F1 Pressing F1 performs the macro assigned to this soft function
key. By default, MUTE is assigned to this key, so pressing F1
toggles mute on or off.
F2 Pressing F2 performs the macro assigned to this soft function
key. By default, CALL is assigned to this key, so pressing F2
starts a call.
F3 Pressing F3 performs the macro assigned to this soft function
key. By default, SCAN is assigned to this key, so pressing F3
switches off scanning, or if you were in a call, ends the call and
switches scanning on.
Hold MUTE Holding MUTE toggles the front panel speaker on or off.
TUNE Pressing TUNE displays the PTT tunes screen so you can
manually tune the antenna.
CLAR Pressing CLAR enables you to adjust the receive frequency to
compensate for any frequency offset between your transceiver
and the remote transceiver.
MODE Pressing MODE selects the next allowable mode programmed
for the channel, usually USB or LSB.
FREE Rx Pressing FREE Rx enters Free Tune mode in which you can
adjust or enter a receive frequency.
Tx PWR Pressing Tx PWR toggles the transmission power of the
transceiver between Hi (25 W) and Lo (5 W).
To Next Page
Loading...
