Getting started
Manpack Transceiver 2110 series Getting Started Guide 49
Scanning channels
Before you can switch scanning on, you need to allocate some
channels to be scanned. If Quick Start is available, you can
create a scan list from channels programmed into the
transceiver (see page 57, Using Quick Start). If this feature is
not available, your system administrator will allocate some
channels to a network, then enable scanning of this network.
Switching scanning on or off
To switch scanning on or off:
1 Press SCAN.
Scanning is toggled on or off.
When scanning is switched on, mute is also switched on.
If you press PTT while the transceiver is scanning, the scan is
paused.
NOTE
SCAN is also used to end a call then
resume scanning.
To Next Page
Loading...
Need help?
General
