Code Electronic Party 500 - 5 Effect

Party500_V1013_EN.PDF http://www.codelight.com
12
5. Effect
There is an Effect Generator in Party 500, which will help you to create various lighting movement with far less
programming.
You'd better use at lest 4 neighboring fixtures to run the effect. Each of Playbacks can run two effects at the same
time, as well as manual control.
After adjusted the channel attributes of Pan/Tilt Location, Color or Gobo and so on, you can select a group of
fixtures to run the moving effect automatically by using Party 500. Use   to turn over the page, use 
 or
S1 - S4 to select a moving effect, Press Enter to confirm.
Using the effect as followed:
 As the way of manually-controlling fixtures, select several neighboring fixtures in the Unit section;
 Press Locate;
 Press S1 [LocateFix.] to turn on the selected fixtures;
 As the way of using Control Wheel to change the fixture attributes, to adjust Pan/Tilt location;
 In the Live Mode, press S4 and enter [Effect];
 Press S1 and enter [Sel Effect];
 Use   to turn over pages, Use   or S1 - S4 to select one of the moving effect;
 Press Enter to confirm running;
 In this menu, use Control Wheel A, B, C to respective control the "Size ", "Speed", "Angle" of the
moving effect.
 You can press S1 again to select running another moving effect simultaneously;
 If two moving effect had run, use   to switch to present state, then you can adjust each of the effect
parameter by using Control Wheel A, B, C;
 Press S3 can change the running direction;
 Certainly, you can press S2 [DEL Effect] to stop running of the enable effect.
After entered the moving effect menu, if you don't choose any effect, you can exit by pressing Exit.