Code Electronic Party 500 - 9 File Management; Upload Show File; Backup Show File; Utilities of USB Flash Drive

Party500_V1013_EN.PDF http://www.codelight.com
25
9. File management
You can insert USB flash drive into the USB jack of the Party 500 and backup the program to the USB flash drive.
Suggestion: you'd better backup the data after you finish programming. It's advisable habit to backup the
documents. Once the unpredictable accidents happened, you can resume it by the backup documents in the USB
flash drive.
Before you perform the following operations, you need to insert the USB flash drive into the USB jack of the
console, (extended line is permitted). Meanwhile, you should insure the USB flash drive is in the FAT or FAT32
format; otherwise you have to format the USB flash driver via PC.
9.1. Upload Show File
The show file includes all the user setting, Preset data and performing program of the console. The file is created
by backup the show file that saved in the USB flash drive.
 Insert the USB flash drive into the USB jack of the console;
 Press Setup to enter “Supervise Menu”;
 Press S1 [FileSystem] and wait until the console list the documents in the USB flash drive;
 Press S1 [Load Show] and use the   cursors to select the needed Show document, whose extended
name is SHO;
 Press S1 [Load Show] to upload the data to the console;
 Press Setup to exit after finished.
9.2. Backup Show File
 Insert the USB flash drive into the USB jack of the console;
 Press Setup to enter "Supervise Menu";
 Press S1 [FileSystem] and wait until the console list the documents in the USB flash drive;
 Press S2 [BackupShow], you will be asked to input the name of Show backup document, which at most
can be input 8 numbers or letters;
 Press S1 [Confirm] to start backup after enter the name of the document;
 Press Setup to exit after finished.
9.3. Utilities of USB Flash Drive
 Press Setup;
 Press S1 [FileSystem];
 Press S3 [Utilities];
Then, there are 3 functions display on the LCD screen, as follow: