Code Electronic Party 500 - Chase; Create a Chase

Party500_V1013_EN.PDF http://www.codelight.com
14
Create a Cue as followed:
 Create the scenes and Effects you need by manual control;
 Press Save to Cue and enter “Record Memory/Cue” menu, then the led of Flash button which have saved
program will twinkle;
 Press S1 or S2 to select record mode;
 If you press the twinkling Flash button, LCD screen display “Playback isn't empty! Overwrite?”, if press
S1 to “Confirm”, the saved content will be overwritten (In spite of the content is Cue or Chase). If you
press the Flash button without twinkle, a new playback will be saved.
6.4. Chase
A chase is composing with some chase steps. Each of which has 3 timing parameters and Link mode parameters,
which are "HTP FadeIn", "LTP FadeIn", "LTP wait".
Each chase step time called independent time. When edit program step, console automatically give out
independent time and Link default value:
HTP FadeIn=0, LTP FadeIn=1, LTP wait=0 (sec.), Link=ON.
Please pay attention: when editing, user can change the independent time value of one of the chase steps. Once it
is changed, the relevant chase step time won't be superseded by the global time.
Each of Chases has a global time as well. When changing the global time of the Chase, the global time will
supersede the default independent time value of the chase step, but won't react on the chase step time which
independent time had been changed. After changing, the global time will be saved.
While Chase is running, you can temporarily use the Control Wheel B to adjust the speed rate of one of the
Playback (PB Speed), adjusting range is 10% - 500%. The Chase global time multiply the percentage is the actual
running time of the present chase step.
When actual running, the Chase global time is use for controlling the basic running speed of the relevant program,
while the PB Speed is use for temporarily changing the Chase speed. The temporarily speed rate won't be saved
when turn off the console, the PB Speed will automatically resume to 100% when turn on the console next time.
6.4.1. Create a Chase
Operate Steps:
 Press Edit Playback and enter “Program Playback” menu;
 Choose the Flash button number of the program which needs edit in the Playback section. (There
are 50 Playbacks, each page contains 10 Playbacks). The led of Playback buttons which have
saved programs will twinkle, those led off are empty. Pressing an empty Flash button means you
will save a new Chase in this button;
 Create the needed scene and Effect by manual control;