Code Electronic Party 500 - Change the Running Direction of Chase and Pause; Music Trigger; Performing Global Time; Change the Speed of Playback Temporarily

Party500_V1013_EN.PDF http://www.codelight.com
18
6.5.3. Change the Running Direction of Chase and Pause
 Set the Playback to the present state first;
 Press Go+ or Go- to change the running direction of Chase;
 Press Pause can stop the Chase and stay at the present step. Press again will continue the Chase.
Note: if the Chase step contains Effects, the Effect will run continuously.
6.5.4. Music Trigger
 Set the Playback to the present state first;
 Press Music Trigger, then the led of button will turn on and the Chase steps will run follow the
rhythm of the music. Press Music Trigger again, the light will be off, and the Chase steps will run
as the preset speed;
 Press Pause can stop; and press Go+ or Go- can change the direction of the Chase.
6.5.5. Performing Global Time
User can change the Global time of each Playback:
 Set the Playback to the present state first;
 Press S2 [Time Edit];
 Select the Playback needed to adjust timing, and change 3 of the timing parameters according to
your needed.
Each Playback global time contains 3 timing:
1. HTP Fade In --- the step time which spend on the HTP Fade in.
2. LTP Fade in --- all of the time which use in LTP Fade in.
3. LTP Wait --- the time between the begin of a step and the begin of an LTP Fade in.
The adjusted global time will automatically save, which availability for the selected Playback and instead
of the default independent time of the Chase steps only. However, the adjusted Chase step independent
time is impregnable.
6.5.6. Change the Speed of Playback temporarily
User can adjust the running speed of the Playback when performing
 Fade in the fader to run Playback;
 Press S1 and enter “PLAYBACK”;
 Press S1 and enter [PB Speed];
 Press Shift and hold still until press the Flash button, in order to set the Playback into present state.
Use Control Wheel B to adjust the Playback speed proportion (there is a "PB Speed" shown on the
LCD screen), adjusting range is: 10% -500%.
This kind of temporarily adjusting Playback speed is a speed of Playback global time multiply with the PB
speed proportion. For example, if the Chase global time = 1 second, when the PB speed = 50%, then the
Chase step running time becomes 0.5 second temporarily.