CR2 User’s Manual Draft_022803_AS - 14
CR2 User’s Manual Draft_022803_AS - 15
Batch Programming Modes
The CR2 can be programmed to operate in two (2) other operating modes:
1. Manual Erase Mode - In manual erase mode, when the reader Is reconnected to your
host computer or when the Bluetooth Radio is back in range and the user scans
another code or the specic transfer data code (Users may also program a button in
section 4.6 to transfer data) the reader will transfer scanned data. However, once the
readers memory has been transferred, the user must scan a specic code to erase the
units memory (see section 4.6). If you enter batch mode again without erasing the
data, the new scanned data will be added to the existing data.
Note: Once the unit is plugged back into a cable or enters within radio range, any
data scanned WILL NOT be saved to the non-volatile memory. The only data that
will be saved is the data scanned while in batch mode.
2. Send and Store Mode - In send and store mode, the reader will automatically try to
transfer scanned data everytime a new code is scanned. In parallel, the unit will also
store a copy of all scanned data on the unit’s non-volatile memory. If the readers
memory has been transferred to a host computer all scanned data will still reside on
the units memory until the user scans a specic code to erase the memory.
Note: All scanned data WILL be saved to the non-volatile memory even if a cable
is attached or the radio is within range.
2.2 - Installation Guide - Batch Interface (con’t)
To Next Page
Loading...
Need help?
General
