CR2 User’s Manual Draft_022803_AS - 78
CR2 User’s Manual Draft_022803_AS - 79
RS-232 Interface Setting Defaults
You must scan the RS-232 commuincation settings code on page 44 to switch the reader in
RS-232 communication mode. When enabled your unit will default to the following settings:
Baud Rate 57600
Stop Bits 2
Data Bits 8
Parity None
Batch Mode Setting Defaults
Your unit will recognize when the USB cable is detached or the bluetooth radio is out of range and
automatically switch into batch mode with the following settings.
Auto Storage Erase On
Send and Store Off
RS-232 Connected On
7.1 - CR2 - Default Settings (con’t)
To Next Page
Loading...
