CR2 User’s Manual Draft_022803_AS - 54
CR2 User’s Manual Draft_022803_AS - 55
CR2 has a time stamp feature for logging data (The time stamp is defaulted off in
shipped units). If you enable the time stamp feature, everytime the CR2 is powered
off or rebooted, the timer will stop.
A 8-digit number represents the time stamp. The format is ddhhmmss (dayday/
hourhour/minuteminute/secondsseconds). Scan the following codes to turn the
time-stamp on/off:
On
Off
4.5 - Time Stamp Settings
To Next Page
Loading...
Need help?
General
