Technical Manual CODEL
49
Press to move cursor to next most significant digit. Repeat
above procedure to increment or decrement and press to
move cursor to next digit and finally press to exit EC CH3 CAL.
8.1.5. VIS CH ZERO CAL: Allows user to activate VIS CH Zero Cal.
Use or to scroll through to VIS CH Zero Cal.
Press to activate Full EC Zero Cal.
8.1.6. Exit: Allows user to exit to main menu.
Use or to scroll through to Exit and press to exit to
Setup mode submenus.
8.2. Parameters: Allows user to change system paramenters. The following are
the submenus.
Parameters
Comms (B,D,P,S)
Protocols
Comms Address
Exit
Use or to scroll through to Parameters.
Press to access Parameters sub menu.
8.2.1. Protocols: Allows user to change comms protocols.
Use or to scroll through to Protocols
Press to set Protocol after using or to scroll through
and choose protocol to be set.
VIS CH Zero CAL
Enter to CAL
4. Setup Mode
4.1. CALIBRATION
4. Setup Mode
4.3. Parameters
Comms (B,D,P,S)
9600,8,0,1
To Next Page
Loading...
Need help?
General
