CODEL Tunnel Tech 700 Series User Manual

Technical Manual CODEL
50
8.2.2. Comms Address 1: Allows user to change comms address.
 Use or to scroll through to Comms Address 1.
 Press to set Comms Address after using or to scroll
through and choose Comms Address to be set.
8.2.3. Exit: Allows user to exit to setup mode submenus.
 Use or to scroll through to Exit and press to exit
to Setup mode submenus.
8.3. Span Factor: Displays Allows user to adjust Cal parameters. The following
are the submenus.
 Span Factor
 EC1 Span Factor
 EC1 Offset
 EC2 Span Factor
 EC2 Offset
 EC3 Span Factor
 EC3 Offset
 VIS Span Factor
 VIS Offset
 Exit
 Use or to scroll through to Span Factor.
 Press to view Span Factor sub menu.
8.3.1. EC1 Span Factor: Adjust EC1 Span Factor.
 Use or to scroll through to EC1 Span Factor.
Set Protocols
CODEL
Comms Address
1
set comms_address
1
EXIT
Enter to Exit
Setup Mode
4.3. Parameters
4. Setup Mode
4.4. Span Factor
EC1 Span Factor
00.000
EC1 Span Factor
00.000

CODEL Tunnel Tech 700 Series Specifications

General

Brand	CODEL
Model	Tunnel Tech 700 Series
Category	Measuring Instruments
Language	English