The Slave shows the following display:
NONSTOP MASTER
SLAVE: passive
Change over [.]
The ' ' key can be used to force a switch over to the momentary passive labeler
NONSTOP SLAVE
Labeler-change....
SLAVE: passive
Change over [.]
The first line of the slave-display indicates a Slave labeler. The second labeler in a nonstop-con-
figuration is always the Slave
Line three of the slave-display represents the status of the slave only
Line four of the Slave display shows the switch over key command (' ' key of the monitor keybo-
ard). This keycommand is used to switch from the active labeler Slave to the passive labeler Ma-
ster. As soon as the dot-key is pressed the Slave display indicates this special mode with the
message Labeler-change... on line two of the display, until the Master has switched over the la-
beling mode (Master is active, Slave is passive)
4.7.2 Nonstop Reset
The Nonstop Reset is used to reset the internal nonstop counter when in nonstop mode. In case
that at the moment of start there are products between the master and the slave the counter can be
set to the appropriate quantity. (This function helps a lot in case of labeling endless products like for-
mulars or foils or when the conveyor cannot be emptied)
Nonstop Reset has to be called up when a fault has occurred in nonstop mode to guarantee a per-
fect labelling of the goods. The Nonstop Reset is called up with ENTER. The following indication
confirms the execution of the reset.
NONSTOP RESET
Goods between
Master-Slave: 0
Note:
This function can be selected only in switched on nonstop mode.
The Nonstop reset can only be done on a Master Collamat.
programmer/operator
RUN/STOP
User level:
Operating mode:
programmer/operator
RUN/STOP
User level:
Operating mode:
5999.530-01E 14.01.2004 CSWM 4 16
To Next Page
Loading...
