6.6 Adapter magnet (only Collamat 9100)
The Adapter magnet function is used to switch on and off the adapter magnet. If set to ON, the ad-
apter is folded towards the good for each labelling operation. The time delay to reset the magnet has
to be entered in the following menu. When set to OFF, the adapter remains in rest position. The
function can be switched on and off by UP and DOWN keys. The ESC key terminates the function:
ADAPTERMAGNET ADAPTERMAGNET
Release Delay
Function : ON
Time : 1.5 Sec
User level: programmer
Operating mode: STOP
6.7 Motor direction
The Motor direction function is used to specify the direction of rotation of the labeller motor with
the arrow keys: right-hand rotation for right-hand labeller version, and left- hand rotation for left-hand
labeller version.
MOTOR DIRECTION
Choice : Right
6.8 POLARITY IFEED
The Polarity IFEED function is used to fix the polarity of the monitor IFEED signal used to communi-
cate with an outside control. The polarities Normal or Inverse can be selected with the arrow keys.
POLARITY IFEED
Choice : Normal
programmer
STOP
User level:
Operating mode:
programmer
STOP
User level:
Operating mode:
5999.530-01E 14.01.2004 CSWM 4 36
To Next Page
Loading...
