ComAp InteliATS NT STD

InteliATS
NT
STD, SW version 2.0, ©ComAp – June 2010 6
IA-NT- STD-2.0-Reference Guide.pdf
WARNING!
E wing InteliATS
NT
controller terminals: very time you want to disconnect follo
- Mains voltage measuring and / or
- Binary output for MCB control and / or
Switch InteliATS
NT
to MAN or OFF Mode or disconnect the Binary outputs Rem Start/Stop and GCB
Close/Open to avoid unexpected automatic start of gen-set and GCB closing.
WARNING!
Dangerous voltage
In no case touch the terminals for voltage and measurement!
Always connect grounding terminals!
The following instructions are for qualified personnel only. To avoid personal injury do not
perform any action not specified in this Reference guide!!!