InteliATS
NT
STD, SW version 2.0, ©ComAp – June 2010 5
IA-NT- STD-2.0-Reference Guide.pdf
es General Guidelin
What is in this manual?
This manual describes the InteliATS
NT
STD (IA-NT-STD) software, which is designed for automatic
s and provides general information on how to install and operate the
• Automatic transfer switch panel builders
otely from InteliATS
NT
)
d maintenance of the gen-set
NT
ns of the
NT-STD-HW_1.3-
.AIL) form the
higher too, which is
ATS
NT
SW must be
rature ATS controller.
transfer switch application
In li
NT
te ATS controller.
This manual is dedicated for
• Operators of remote gen-sets (started rem
• For everybody who is concerned with installation, operation an
InteliATS controller SW and HW versions compatibility
Software InteliATS
NT
is compatible with the InteliATS
NT
hardware v. 1.3 and higher.
There are two modifications of the InteliATS HW - STD and PWR and two modificatio
InteliATS
NT
SW – STD and PWR which together with the appropriate archive file (IA-
X.X.AIL for STD HW 1.3, IA-NT-STD-X.X.AIL for STD HW > 1.3 and IA-NT-PWR-X.X
InteliATS
NT
PWR or STD controller.
Beside that the InteliATS
NT
software is compatible with IL-NT AMF HW 1.3 and
used when a low temperature ATS application is needed. In this case the Inteli
combined (purchased) with the IL-NT AMF 25 LT HW to obtain the low tempe
NOTE:
Because of large variety of InteliATS
NT
parameters settings, it is not possible to describe any
combination. Some of InteliATS
NT
functions are subject of changes depend on SW version.
The data in this manual only describes the product and are not warranty of performance or
characteristic.
CAUTION!
SW and HW must be compatible (e.g. IA-NT firmware and IA-NT HW) otherwise the function will be
disabled. If wrong software is downloaded, message HARDWARE INCOMPATIBLE appears on
controller screen. In this case use Boot load (jumper) programming – close Boot jumper and follow
instructions in LiteEdit, download correct software.
NOTE:
C rmation provided herein is correct and reliable and reserves the right to omAp believes that all info
u omAp does not assume any responsibility for its use unless otherwise expressly pdate at any time. C
undertaken.
WARNING!
Remote control - InteliATS
NT
controller can be remotely controlled. In case of the work on the
controlled devices check, that nobody can perform remote operation.To be sure disconnect
- remote control via RS232 line
- input REM TRANSFER
- input REMOTE AUT
- input REMOTE TEST
or disconnect output Rem START/ST utputs GCB CLOSE/OPEN and MCB CLOSE/OPEN
OP and o
To Next Page
Loading...
Need help?
General
