ComAp InteliDrive FLX LITE - Technical Data

9 Technical data
Power supply
range
8-36 V DC
Power supply
drop-out immunity
100 ms from min. 10 V return to
min. 8 V
Power
consumption
40-440 mA depend on supply
voltage and temperature
Consumption
depends on
supply voltage
0.104 A / 8 V DC
0.080 A / 12 V DC
0.051 A / 24 V DC
0.044 A / 30 V DC
0.040 A / 36 V DC
Battery voltage
measurement
tolerance
2 % at 24 V
Power supply
Note: For the supply voltage less than 7V the
backlight of the display is switched off. Short-term
voltage drops (e.g. during the engine cranking) do
not affect the operation at all.
Operating temperature
InteliDrive Lite
-20 ˚C to +70 ˚C
Storage temperature -30 ˚C to +80 ˚C
Protection front panel IP65
Impact protection EN 62262, EN 50102 (IK04)
Humidity 95 % w/o condensation
Low Voltage Directive not applied
Electromagnetic
Compatibility
EN 50081-1:94, EN
50081-2:96
EN 50082-1:99, EN
50082-2:97
Vibration
5-25 Hz, ±1.6 mm
25-100 Hz, a = 4 g
Shocks a = 200 m/s
2
Operating conditions
Dimensions 180 × 120 × 55 mm
Weight 450 g
Dimensions and weight
Number of inputs 7
Input resistance 4.2 kΩ
Input range 0-36 V DC
Switching voltage
level for
close/open
contact indication
0-2 V DC close contact;
8-36 V DC open contact
Binary inputs
Number of
outputs
7
Maximum current 0.5 A
Max switching
voltage
36 V DC
Binary outputs
Number of inputs 9, 3 resistive and 6 voltage
Resolution 10 bits
Wiring selectable
range
V, Ω, mA
Maximal resistance
range
2400 Ω
Maximal voltage
range
0-10V (0-40V for AIN4+5)
Resistance
measurement
tolerance
±2 % ±2 Ω out of measured value
Voltage accuracy
1 %, ±100mV (±400mV for AIN4-
5)
Resistance
accuracy
4% ±5Ω
Analog inputs
Minimum input
voltage
2 Vpk-pk (from 4 Hz to 4 kHz)
Maximum input
voltage
50 Veff
Measured
frequency
4 Hz to 10 kHz
Frequency
measurement
tolerance
0.2 %
Speed pick-up input
Max. D+ output
current
300 mA
Guaranteed level
for signal
80 % of supply voltage
D+ function
Max CAN bus
length
200 m
Speed 250 kBd
Nominal
impedance
120 Ω
Cable type twisted pair (shielded)
Nominal Velocity
min. 75 % (max. 4.4 ns/m)
CAN bus interface
ID-FLX Lite Global Guide
90