ID-FLX Lite Global Guide
87
8.4 ECU engine support
ID-Lite firmware branch covers both standard and electronic controlled (monitored) engines. The appropriate
engine / ECU type is selected in PC tool LiteEdit like other peripheries. Press the button in LiteEdit
configuration window Modify.
Note: Import latest ECU list – ECU list-x.x.iwe for update engine ECU specification.
Select the proper esl file in LiteEdit->Options->ESL files - typically Allspeed.esl.
IMPORTANT: More information about ECU list packages, values, configuration and wiring
recommendations can be found in Comap Electronic Engines Support manual.
The ID-Lite controller always sends either speed request = 0% or the IDLE command via J1939 in controller
Idle state. In the MAN mode the Idle operation can be controlled by NOMINAL/IDLE (PAGE 192).
8.5 Choosing the ECU to configure
According to the model of ECU, choose and configure the right ECU option. The configuration can be made in
LiteEdit, the window Modify, icon ECU.
Note: If the connected engine is Cummins communicating via RS232, it is necessary to set the setpoint Basic
settings: COM1 mode (or COM2 mode if IL-NT RS232-485) = ECULINK.
Loss of communication causes shutdown of the running engine. On the contrary, the ECU can be switched off
at quiescent engine that means not-communicating ECU is in that moment normal situation. All values from
To Next Page
Loading...
