ComAp InteliDrive FLX LITE - Setpoints; List of Setpoint Groups; Password; Enterpassword

ID-FLX Lite Global Guide
94
10.1.1 Setpoints
What setpoints are:
Configuration of setpoints is possible through panel buttons as is described above or via ComAp PC tool
LiteEdit, where the setting can be open by click on the icon .
List of setpoint groups
Group: Basic settings 98
Group: Communication settings 106
Group: Engine parameters 114
Group: Regulator 129
Group: Load limit 135
Group: Engine protection 139
Group: Date/Time 167
Group: Sensors Spec 172
Group: AIO module 177
Group: Act. Calls/SMS 181
Group: ATTsettings 183
For full list of setpoints go to the chapter List of setpoints (page 95).
Password
EnterPassword
Password is a four-digit number. Password enables change of relevant protected set points Use ↑ or ↓ keys to
set and ENTER key to enter the password. There are 3 levels of passwords. Knowledge of higher password lets
you to change setpoint protected by lower password.
ChangePassword
Use ↑ or ↓ button to set and ENTER button to change the password.
Note: At first the Password has to be entered before the new Password can be changed.
Can be used LiteEdit PC tool for changes of Password level in window Modify press button Password for
each of three levels can be adjusted from the menu Controller->Change password…