InteliLite Global Guide
324
Setpoint group
CM-GPRS; CM-4G-
GPS
Related FW 1.2.1
Range [units] 0..31 characters [-]
Default value [-] Alternative config NO
Step [-]
Comm object 24142 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
Enter in this setpoint either a valid GSM phone number where the alarm messages shall be sent. For GSM
numbers use either the national format (i.e. the number you would dial if you wanted to make a local call) or
the full international format beginning with a “+” character followed by the country prefix.
IMPORTANT: Telephone number has to be entered without spaces.
Telephone Number 4
6 back to List of setpoints
Setpoint group
CM-GPRS; CM-4G-
GPS
Related FW 1.2.1
Range [units] DISABLED / ENABLED [-]
Default value ENABLED Alternative config NO
Step [-]
Comm object 24273 Related applications AMF, MRS
Config level Standard
Setpoint visibility
Only if relevant module is installed + conditioned by the setpoint Mode (page 314)
Description
This setpoint enable or disable AirGate connection via CM-GPRS or via CM-4G-GPS.
DISABLED: Only SMS are sent. Internet-enabled SIM card is not required. AirGate is not used.
ENABLED This mode uses the “AirGate” service. Internet-enabled SIM card must be used. The
AirGate server address is adjusted by the setpoint AirGate Address (page 337).
IMPORTANT: When this setpoint is changed the controller has to be restarted to apply
changes.
AirGate Connection
6 back to List of setpoints
To Next Page
Loading...
