ComAp InteliPro - InteliPro Installation Data; Unit Unpacking and Contents; Mechanical Mounting Guidelines

InteliPro, SW version 1.0, ©ComAp – May 2011
InteliPro Installation and Operation Guide
1-4
Installation data
Unpacking the unit - what is in the package
The package contains:
• InteliPro unit
• Relay Card CT2-REL2 plug-in module (plugged in the unit)
• Mounting holders
• Terminal blocks
NOTE:
The package does not contain any communication module nor any extension module. The required
module should be ordered separately.
Mechanical mounting
The unit is to be mounted onto the switchboard door. Requested cutout size is 175x115mm. Use the
screw holders delivered with the unit to fix the controller into the door as described on pictures below.