InteliPro, SW version 1.0, ©ComAp – May 2011
InteliPro Reference Guide
4-36
Input resistance 4,2 kOhm
Binary outputs
Number of binary outputs 8
Galvanic insulation Not insulated
Type Transistor, switching to negative supply terminal
Operating voltage 8-36VDC
Switching current 500mA (suppresion diodes required for inductive loads)
Analog inputs
Number of analog inputs 3
Galvanic insulation Not insulated
Electrical range 0-2500ohm
Resolution 10bits, 4digits
Supported sensor types
Predefined: VDO 10Bar, VDO Temperature, VDO Fuel level
User defined: 10 points non-linear sensors can be defined by the
user
Precision 1% from the range
Mains measurements
Measurement inputs 3ph mains voltage, 3ph mains current, NVD voltage, Sync Check
Measurement type True RMS
Voltage range 480V Ph-Ph (277V Ph-N)
Max. measured voltage 340V Ph-N
Voltage accuracy 1% from the range
Current range 5A
Max. measured current 9A
Max. allowed current 12A continous, 50A/1s
Current accuracy 2% from the range
CT input burden <0.5VA
Frequency range 30-70Hz, measured from L3
Frequency accuracy 0.05Hz
Remote communication interface
RS232 Optional using the plug-in module IL-NT-RS232, D-SUB9M socket
RS485
Optional using the plug-in module IL-NT-RS232-485, plug-in
terminal block
Baud rate Depending on selected mode (up to 57600 bps)
USB Optional using the plug-in module IL-NT-S-USB
Ethernet Optional using the plug-in module IB-Lite
Extesion modules interface
Type CAN bus
Galvanic insulation Insulated, 500V
To Next Page
Loading...
