80
HS-RC-C5E-AM-PPS_01.fm
00/0411
e. Remove the module by slightly
moving away the lower part,
then lift it.
f. In case of resistance due to the
friction with the adjoining
modules:
– loosen all Allen screws of the
adjoining module.
– If that is not sufficient, keep on
loosening all screws of all
installed modules.
Illustrating picture with AMS-IAM module highlighted
g. Make sure the module bottom wall and the supporting area on the dissipator are
both perfectly clean.
h. Mount the new module in the
slot hooking it first from the
upper part, then lower it while
pushing it against the
dissipator.
Operating procedure (Continued)
To Next Page
Loading...