81
HS-RC-C5E-AM-PPS_01.fm
00/0411
i. Tighten the Allen screws (G) by
5 Nm.
j. Tighten the Allen screws (F) by
5 Nm.
k. Place back all connectors (B), making sure the fitting is followed by a sharp “click”
indicating the fitting has been completely accomplished.
l. Place back all connectors (A) and (D).
m. If necessary, refer to the connectors and modules table included in the diagram
posted inside the Control Unit door.
n. Lower the lexan lower cover on the module.
Follow-up procedure
– Not required.
Operating procedure (Continued)
To Next Page
Loading...