CombiLift C3000CB - Driving Position; Parking; Bridge Plates and Dock Boards; Lifting the Machine

Combilift Ltd C2500-C3000CB O&S Manual
3-2
C2500CB-OM-EN-11
3.4: Driving Position
 Only operate controls from the correct driving position and do not operate
any control until you are certain of its function.
3.5: Parking
 Apply parking brake by pressing the red button.
 Ensure that the direction control switch is set to neutral.
 Lower the forks fully.
 Park clear of aisles, doorways, stairways and fire points and ensure that
the truck will not obstruct other traffic.
3.6: Bridge Plates and Dock Boards
 Bridge plates and dock boards must have an adequate safety factor to
support a loaded truck and be secured when in use to prevent accidental
movement.
 Do not exceed the maximum permissible load, which must be clearly
marked on all bridge plates and dock boards.
 The sides of bridge plates, and where possible dock boards, must be
raised to minimise the possibility of the truck being driven over the edge.
 The surface of the above equipment must be of a slip resistant substance.
 Drive slowly when crossing bridge plates and dock boards.
3.7: Lifting the Machine
 Lift the machine only when necessary.
 Check machine weight before lifting
 Use only the two lifting points on the mast and ensure that the mast is
tilted back before lifting.